J&P Community

I was just cleaning my "early" (Pre-CV) Keihin carburetor and managed to break the overflow tube in the float bowl. Is there ANY WAY to fix this? I mean, can I just epoxy the overflow hole the tube was in if I swear I'll turn the petcock off every time I stop the engine? Sure, I'd LOVE...

I have adjusted,purchased & replaced all cables, handgrip on my 2005 Fatboy. My throttle will not return to idle no tension. When I tune the throttle open there is slack in the retun cable. I can't adjust it out, the throttle gets harder to turn. have taken extra care to install cables on carb...

i can crank it up and let it idle for a while and get good and wormed up and then ride and even then it may hickup through the carb.when i say hickup ,thats the best way ican describe it or maybe a burp.it runs strong and all and when it does do it its mostly when i up trottle.i bought the bike at 15000...

I am building a custom softail right now and am at a point that a little info will go a long way. To start I had a custom frame built by wareagle which took 3yrs to actually get from them. I have inserted a S&S 145" Tribute with a 6-speed right side drive tranny and chain final drive to a Avon...